Versions Compared

Version Old Version 33 New Version 34
Changes made by

dani.simmonds

dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Cartridges Involved

This Configuration element involves the following Cartridges.

Info

Note: Not all cartridges are available for all CMC models.

...

Opening Cuts too Far to the Right when Not Cutting the Outside: Horizontal Border too Big

Problem:

  • The opening is cut too far to the right Horizontally.

Resolution:

  • Decrease the Horizontal Home.

  • The opening will move to the left.

Info

  • When making adjustmentsTo adjust, click the plusor minus button at the end of the desired /minus on the field about five times.

  • Click OK and do another test cut.

  • Check the results of the cut and continue Continue making adjustments until the desired outcome is achieved.

Opening Cuts too Far to the Left when Not Cutting the Outside: Horizontal Border too Small

Problem:

  • The opening cut cut too far to the left horizontally.

Resolution:

  • Increase the Horizontal home.

  • The opening will move to the right.

Info

  • When making adjustmentsTo adjust, click the plusor /minus button at the end of the desired on the field about five times.

  • Click OK and do another test cut.

  • Check the results of the cut and continue Continue making adjustments until the desired outcome is achieved.

See Also: Horizontal Home Troubleshooting

Info

See Also: Adjusting the Horizontal Position for Non-Blade Cartridges

Info