Page Comparison

Cartridges Involved

This Configuration element involves the following Cartridges.

Info
Note: Not all cartridges are available for all CMC models.

Info
The Outside Rotation controls for Swoopsor Flareson the outside cut on non-oval V-Grooves.

The first cut is the interior

Info

Tip

First Cut of V-Groove

line and cut into the

:

Cuts the Interior V-Groove Line.
Cuts into falloutand , not the matboard, and is cut in a clockwise direction. .
Cuts clockwise.
This uses the Inside Rotation.The second cut is the exterior

Second Cut of V-Groove:

Cuts the Exterior V-Groove line and cut into the matboard and not on the V-Groove fallout, and is cut in a Line.
Cuts into matboard, not the fallout.
Cuts counter-clockwise direction.
This uses the Outside Rotation.

Info
When making adjustments, click the plus or minus button at the end of the desired field about four times. In Rotation, eight points equals one degree of rotation. Users usually make adjustments four points at a time. Click OK and do another test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved.

Info
When making adjustments, click the plus or minus button at the end of the desired field about four times. In Rotation, eight points equals one degree of rotation. Users usually make adjustments four points at a time. Click OK and do another test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved.

Use the Troubleshooting Configurations to fine-tune for Swoop/Flare in a Non-Oval V-Groove.