Versions Compared

Version Old Version 14 New Version 15
Changes made by

dani.simmonds

dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Cartridges Involved

This Configuration element involves the following Cartridges.

Note: Not all cartridges are available for all CMC models.

...

Crease Exterior Backup is too Long

Problem:

  • The Crease Exterior Backup is

applied

  • too Long.

Resolution:

  • Adjust the Crease Exterior Backup. Select this topic to see information on editing the Exterior Backup.

Info

  • This is viewed from the front of the mat.

Crease Exterior Backup is too Short

Problem:

  • The Crease Exterior Backup is

applied

  • too Short.

Resolution:

Adjust the Crease Exterior Backup. Select this topic to see information on editing the Crease Exterior Backup.

Info

  • This is viewed from the front of the mat.

Crease Exterior Overcut is too Long

Problem:

  • The Crease Exterior Overcut is applied too Long.

Resolution:

  • Adjust the Crease Exterior Overcut. Select this topic to see information on editing the Crease Exterior Overcut.

Info

  • This is viewed from the front of the mat.

Crease Exterior Overcut is too Short

Problem:

  • The Crease Exterior Overcut is applied too Short.

Resolution:

  • Adjust the Crease Exterior Overcut. Select this topic to see information on editing the Crease Exterior Overcut.

Info

  • This is viewed from the front of the mat.

Crease is the Wrong Size

Problem:

  • Crease is applied at the Wrong Size.

Resolution:

  • Adjust the Crease Opening Adjustment. Select this topic to see information on editing the Opening Adjustment.

Info

  • This is viewed from the front of the mat.

Crease is Applied at the Wrong Depth When Using a SKU

Problem:

  • The Crease is applied at the Wrong Depth When Using a SKU.

Resolution:

  • Adjust the Crease Depth Bias. Select this topic to see information on editing the Depth Bias.

Troubleshooting Button 

Info

  • Select this topic to see information on editing with the Troubleshooting utility to make quick edits to the Configurations for a single object on the Cutting Preview. 

Set Box Defaults

  • Set up the Box Defaults for the Crease cartridge in the Admin Editor section of the software.