Page Comparison

Cartridges Involved

This Configuration element involves the following Cartridges.

Note: Not all cartridges are available for all CMC models.

The Oval Rotation controls for Bumps Feather or FeathersBumpon the Oval Openings.

Current Bevel Type
Select the desired Cartridge Type Tab. Select the desired bevel type from the Current Bevel Type dropdown control. Select Current Bevel Type-Front of Mat if it is being cut from the front of the mat.

The Oval Openings is cut with a bump.

Increase the Oval Rotation. Adjust until the object cuts without a Bump.

When making adjustments, click the plus or minus button at the end of the desired field about four times.
In Rotation, eight points equals one degree of rotation. Users usually make adjustments four points at a time.
Click OK and do another test cut.
Check the results of the cut and continue making adjustments until the desired outcome is achieved.

The Oval Openings is cut with a feather.

Decrease the Oval Rotation. Adjust until the object cuts without a Feather.

When making adjustments, click the plus or minus button at the end of the desired field about four times.
In Rotation, eight points equals one degree of rotation. Users usually make adjustments four points at a time.
Click OK and do another test cut.
Check the results of the cut and continue making adjustments until the desired outcome is achieved.

Use the Troubleshooting Configurations to fine-tune for Bumps/Feathers in an Oval Opening.

Use the Circle/Oval Rotation Utility to fine-tune specific sizes of circles/ovals for Feathers and Bumps.