Versions Compared

Version Old Version 26 New Version 27
Changes made by

dani.simmonds

dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Cartridges Involved

This Configuration element involves the following Cartridges.

Note: Not all cartridges are available for all CMC models.

...

Opening Cuts too Far to the Right when Not Cutting the Outside: Horizontal Border too Big

Problem:

  • The opening is cut too far to the right Horizontally.

Resolution:

  • Decrease the Horizontal Home. The opening will move to the left.

When making adjustments, click the plus or minus button at the end of the desired field about five times.

Click OK and do another test cut.

Check the results of the cut and continue making adjustments until the desired outcome is achieved.

Opening Cuts too Far to the Left when Not Cutting the Outside: Horizontal Border too Small

Problem:

  • The opening cut cut too far to the left horizontally.

Resolution:

  • Increase the Horizontal home. The opening will move to the right.

When making adjustments, click the plus or minus button at the end of the desired field about five times.

Click OK and do another test cut.

Check the results of the cut and continue making adjustments until the desired outcome is achieved.

Horizontal Home Troubleshooting

Adjusting the Horizontal Position for Non-Blade Cartridges