Versions Compared

Version Old Version 13 New Version 14
Changes made by

dani.simmonds

dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Cartridges Involved

This Configuration element involves the following Cartridges.

Note: Not all cartridges are available for all CMC models.

...

  • This is viewed from the front of the mat.

    • Crease Exterior Backup is too Long

    Problem:

    • The Crease Exterior Backup is applied too Long.

    Resolution:

    • Adjust the Crease Exterior Backup. Select this topic to see information on editing the Exterior Backup.

    • This is viewed from the front of the mat.

    Crease Exterior Backup is too Short

  • This is viewed from the front of the mat.

    • Problem:

    • The Crease Exterior Backup is applied too Short.

    Resolution:

    • Adjust the Crease Exterior Backup. Select this topic to see information on editing the editing the Crease Exterior Backup.

    • This is viewed from the front of the mat.

  • This is viewed from the front of the mat.

    • Crease Exterior Overcut is too Long

    Problem:

    • The Crease Exterior Overcut is applied too Long.

    Resolution:

    • Adjust the Crease Exterior Overcut. Select this topic to see information on editing the editing the Crease Exterior Overcut.

    • This is viewed from the front of the mat.

  • This is viewed from the front of the mat.

    • Crease Exterior Overcut is too Short

    Problem:

    • The Crease Exterior Overcut is applied too Short.

    Resolution:

    • Adjust the Crease Exterior Overcut. Select this topic to see information on editing the editing the Crease Exterior Overcut.

    • This is viewed from the front of the mat.

    Crease is the Wrong Size

    Problem:

    • This Crease is viewed from the front of the mat. applied at the Wrong Size.

    Resolution:

    • Adjust the Crease Opening Adjustment. Select this topic to see information on editing the Opening Adjustment.

    • This is viewed from the front of the mat.

    Crease

    Cuts

    is Applied at the Wrong Depth When Using a SKU

    Problem:

    • The Crease is applied at the Wrong Depth When Using a SKU.

    Resolution:

    • Adjust the Crease Depth Bias. Select this topic to see information on editing the Depth Bias.

    Troubleshooting Button 

    • Select this topic to see information on editing with the Troubleshooting utility to make quick edits to the Configurations for a single object on the Cutting Preview. 

    Set Box Defaults

    • Set up the Box Defaults for the Crease cartridge in the Admin Editor section of the software.