Page Comparison

This Configuration element involves the following Cartridges.

Note: Not all cartridges are available for all CMC models.

The Rotation field controls how much the foot block will rotate before cutting. Because this is a V-Groove, you will be using either the Outside Rotation or the Inside Rotation, based on which V-Groove line you are editing.

• The first cut is the interior V-Groove line.

• The second cut is the exterior V-Groove line.

Adjust the Outside Rotation if you are getting Swoopsor Flaresin the outside corners on a non-oval opening.

• Increase the Outside Rotationif the object has a Swoop on the outside cut of the V-Groove.

• Decrease the Outside Rotationif the object has a Flare on the outside cut of the V-Groove.

• The beginning of the outside cut of the V-Groove Swoops toward the non-oval V-Groove opening.

• Decrease the Outside Rotation.

• When making adjustments, click the minus button (-) at the end of the desired field about five or six times.

• Click OK and do a test cut.

• Check the results of the cut and continue making adjustments until the desired outcome is achieved.

• The object will now cut correctly.

• The beginning of the outside cut of the V-Groove Flares away from the non-oval V-Groove opening.  

• Increase the Outside Rotation value. 

• When making adjustments, click the plus button (+) at the end of the desired field about five or six times.

• Click OK and do a test cut.

• Check the results of the cut and continue making adjustments until the desired outcome is achieved.

• The object will now cut correctly.