Versions Compared

Old Version 6

changes.mady.by.user dani.simmonds

Saved on

compared with

New Version 7

changes.mady.by.user dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Change to the 90 Degree Blade Cartridge

  • The 90° blade cartridge is labeled 90° on the end and is green. 

  • Push blade cartridge release down to eject the current blade cartridge.

  • Turn 90 degree cartridge over and reinsert into the head with the blade facing the CMC board and the notch on the back of the cartridge facing the head, until it clicks into place. It can only be inserted one way.

Image Removed

  • Remove the blade from blade cartridge; be careful of the sharp edge.

Image Removed

  • The blade cartridge displays a diagram of the blade orientation (shown in contrast). 

  • Place new blade into cartridge with the longest straight side to the right and the bevel face down, lining up the holes of the blade over the pins in the cartridge.

  • The blade should fit snugly into the recess space provided for it.

Image RemovedImage Added

  • Turn cartridge over and reinsert into the head with the blade facing the CMC board and the notch on the back of the cartridge facing the head, until it clicks into place. It can only be inserted one way.

  • If there is side-to-side movement of the blade in the blade cartridge, or if chunks have been cut out of it, then it is time to replace the blade cartridge.