Page Comparison

The Rotation field controls how much the foot block will rotate before cutting. Because this is a V-Groove, you will be using either the Outside Rotation or the Inside Rotation, based on which V-Groove line you are editing.

• The first cut is the interior V-Groove line.

• The second cut is the exterior V-Groove line.

Adjust the Inside/Outside Rotation if you are getting Swoopsor Flaresin the corners on a non-oval opening.

• Increase the Outside Rotationto turn the foot block clockwise to correct for if the object has a Swoop on the outside cut of the V-Groove.

• Decrease the Outside Rotationto turn the foot block counterclockwise to correct for if the object has a Flare on the outside cut of the V-Groove.

• Increase the Inside Rotationto turn the foot block clockwise to correct for if the object has a Swoop on the inside cut of the V-Groove.

• Decrease the Inside Rotationto turn the foot block counterclockwise to correct for if the object has a Flare on the inside cut of the V-Groove.