You are viewing an old version of this page. View the current version.
Compare with Current View Page History
« Previous Version 61 Next »
If the Overcut is Too Long, Decrease the Overcut.
If the Overcut is Too Short, Increase the Overcut.
For Additional Information: See Using the Backup and Overcut Display on the Cut Preview for Troubleshooting.
Select desired Cartridge Tab.
Select the desired Bevel Type from Current Bevel Type.
Edit the desired Configuration field.
When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.
Click OK and do another test cut.
Continue making adjustments until the desired outcome is achieved.
The Overcut controls where the cartridge Retracts from the Matboard.
If the Overcut is cut Too Long, Decrease the Overcut.
If the Overcut is cut Too Short, Increase the Overcut.
The Overcut field is marked with a Red Arrow on the Configuration screen and the Map illustration.
See: Overcut for Creases Configurations
