This FrameShop Online Help System is for an older Version of FrameShop.+">This FrameShop Online Help System is for an older Version of FrameShop.

The updated 7.x FrameShop Online Help can be found here: https://wizardcutters.atlassian.net/wiki/x/hgApYw

If you are running FrameShop version FrameShop 4.1 or above you can update your software by clicking on Options then Check For Update.

What to Expect When Updating to FrameShop 7x from FrameShop 4x: https://wizardcutters.atlassian.net/wiki/x/AQDWaQ

FrameShop Installation Documents: https://wizardcutters.atlassian.net/wiki/x/_1snYw

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Next »

Continuous Layer

Use the Continuous Layer toggle to repeatedly cut the current layer exclusively without rolling over to the next layer.

Continuous Layer On

Click the Continuous Layer toggle On to cut the current layer continuously without rolling over to the next layer.

Click the Continuous Layer toggle On. 

The system will not roll over to the next layer after cutting the current layer.

It will stay on the current layer until the user manually selects a different layer or turns off Continuous Layer.

Continuous Layer Off 

Click the Continuous Layer toggle Off to allow the system to roll over to the next layer after cutting the current layer.

Click the Continuous Layer toggle Off. 

The system will automatically roll over to the next layer after cutting the current layer.

Set the Default for Continuous Layer

Set the default setting for using the Continuous Layer feature under Admin > Cutting.

It will use this default setting on the Cut Preview screen. 

  • No labels