">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 30 Next »

Cartridges Involved

This Configuration element involves the following Cartridges.

Note: Not all cartridges are available for all CMC models.

Rotation on Outsides Definition

 Rotation Definition

The Rotation controls for Swoops and Flares in non-oval objects.

  • To adjust, click plus/minus on the desired field about five times.

  • Click OK and do another test cut.

  • Continue making adjustments until the desired outcome is achieved.

Current Bevel Type

Outside has a Swoop

Problem:

  • The beginning of the cut swoops toward the Non-Oval Outside.

 Rotation Definition

The Rotation controls for Swoops and Flares in non-oval objects.

Resolution:

  • Increase the Rotation.

Outside has a Flare

Problem:

  • The beginning of the cut flares away from the Non-Oval Outside.

 Rotation Definition

The Rotation controls for Swoops and Flares in non-oval objects.

Resolution:

  • Decrease the Rotation.

Twisted Corner

Problem:

  • A Twisted Corner is when the blade turns before retracting from the matboard, which tears the matboard and twists the corner.

  • This is especially visible from the back of the mat.

 Rotation Definition

The Rotation controls for Swoops and Flares in non-oval objects.

Resolution:

  • Check to make sure the Rotation hasn't been set to a high number. 

  • Twisted corners can also be a symptom of oil/water in the Air Valve, or an issue with the Head.

  • Check the Air Regulator for excess water.

  • Use the Clean the Foot Block procedure for cleaning the foot block. 

  • No labels