/
Air Regulator

Air Regulator

Owned by dani.simmonds
Last updated: Mar 07, 2025
1 min read

  • The Air Regulator controls the primary air pressure for the CMC and helps control the pressure for the Clamps, Head Plunge, Blade Plunge and Blade Depth.

Usage:

  • The Air Regulator pressure is usually set around 60-70 psi.

    • It is set at the factory and does not need adjusting.

  • The Air Regulator is self releasing when the Air Compressor is turned off.

  • Check the Air Regulator at least once a week for any buildup of moisture or oil.

Connections:

  • The Air Regulator is connected between the Board and the Air Compressor.

Air Regulator

Troubleshooting:

  • Q: If the matboard is being pushed aside when you try to cut because the Air Clamps are not inflating:

    • A: Make sure that the Air Compressor is on.

  • Q: When you first turn on your Air Compressor, you may hear air escaping from the Air Regulator.

    • A: It will do this until it builds up enough pressure and will seal itself off.

Related Links

Related Links

Related content