">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 11 Next »

Cartridges Involved

This Configuration element involves the following Cartridges.

Note: Not all cartridges are available for all CMC models.

Oval Rotation Definition

The Oval Rotation field controls how much the foot block will rotate before cutting.

Adjust the Oval Rotation if you are getting Bumps or Feathers on an oval opening.

If you have too much rotation on an oval opening, you will get a Feather, too little and you will get a Bump.

Current Bevel Type

Degrees of Rotation for Oval Openings

In Oval Rotation, eight points equals one degree of rotation. 

Users usually make adjustments 4 points at a time.

Oval Opening has a Bump

  • The blade returns to the outside of the starting point of an oval opening, creating a bump in the oval.

  • Increase the Oval Rotation.

  • When making adjustments, click the plus button (+) at the end of the desired field about five or six times.

  • Click OK and do a test cut.

  • Check the results of the cut and continue making adjustments until the desired outcome is achieved.

  • The object will now cut correctly.

Oval Opening has a Feather

  • The blade returns to the inside of the starting point of an oval opening, creating a feather in the oval.

  • Decrease the Oval Rotation.

  • When making adjustments, click the minus button (-) at the end of the desired field about five or six times.

  • Click OK and do a test cut.

  • Check the results of the cut and continue making adjustments until the desired outcome is achieved.

  • The object will now cut correctly.

Circle/Oval Rotation Utility

  • No labels