Cartridges Involved | |
|---|---|
This Configuration element involves the following Cartridges. Note: Not all cartridges are available for all CMC models. | |
V-Groove Outside Rotation | |
|---|---|
Adjust the Outside Rotation if you are getting Swoops or Flares in the corners of a non-oval V-Groove. The Outside Rotation controls how much the foot block will rotate before cutting the outside of the V-Groove. The outside cuts of the V-Groove are Exterior cuts, and cut into the matboard and not the V-Groove fallout. They cut on the second pass of the V-Groove, and are cut in a counterclockwise direction. If you have too much Outside Rotation on a non-oval V-Groove you will get a Swoop, too little rotation and you will get a Flare. | |
V-Groove Outside has a Swoop | |
|---|---|
The beginning of the outside cut of the V-Groove Swoops toward the non-oval V-Groove opening. | |
Decrease the Outside Rotation. | |
The object will now cut correctly. | |
When making adjustments, click either the minus or plus button (-/+) at the end of the desired field about five or six times in the direction indicated. Click OK and do a test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved. | |
V-Groove Outside has a Flare | |
|---|---|
The beginning of the outside cut of the V-Groove Flares away from the non-oval V-Groove opening. | |
Increase the Outside Rotation value. | |
The object will now cut correctly. | |
When making adjustments, click either the minus or plus button (-/+) at the end of the desired field about five or six times in the direction indicated. Click OK and do a test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved. | |
V-Groove Inside Rotation | |
|---|---|
Select this topic to see information on the Inside Rotation (V-Groove) to adjust the rotation for the inside cut of the non-oval V-Groove. | |