">
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this content. View the current version.

Compare with Current View Version History

« Previous Version 26 Next »

Cartridges Involved

This Configuration element involves the following Cartridges.

Note: Not all cartridges are available for all CMC models.

Exterior Overcut on Creases Definition

  • The Exterior Overcut controls where the cartridge retracts from the matboard on exterior cuts.

  • The Exterior cuts into the matboard, not the fallout.

  • The Exterior Overcut field is marked with a Red Arrow.

Current Crease Bevel Type

  • Crease

  • The Exterior Overcut is displayed on the Configuration Map and on the associated field as a red arrow.

Crease Exterior Overcut Too Long

Problem:

  • The Exterior Overcut is applied too long.

Resolution:

  • Decrease the Exterior Overcut.

  • To adjust, click plus/minus on the field about five times.

  • Click OK and do another test cut.

  • Continue making adjustments until the desired outcome is achieved.

Crease Exterior Overcut Too Short

Problem:

  • The Exterior Overcut is applied too short.

Resolution:

  • Increase the Exterior Overcut.

  • To adjust, click plus/minus on the field about five times.

  • Click OK and do another test cut.

  • Continue making adjustments until the desired outcome is achieved.

  • No labels