">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 39 Next »

Cartridges Involved

This Configuration element involves the following Cartridges.

Note: Not all cartridges are available for all CMC models.

Editing the Interior Backup on the Outsides

 Interior Backup Definition

The Interior Backup controls where the Blade Plunges into the Fallout (not the Matboard) on the Interior cuts of Non-Oval Openings.

The Interior Backup field is marked with a Black Arrow on the Configuration screen and the Map illustration.

If the Interior Backup is cut Too Long, Decrease the Interior Backup.

If the Interior Backup is cut Too Short, Increase the Interior Backup.

Selecting the Interior Backup in the Configurations

  • The different Bevel Types, including whether it is cutting from the Front or Back, controls the cut direction of the Head, and determines whether the cut is a Backup or an Overcut.

Adjusting the Interior Backup

  • To adjust, click Plus/Minus on the desired field about five times.

  • Click OK and do another test cut.

  • Continue making adjustments until the desired outcome is achieved.

Outside Interior Backup Too Long

Problem:

  • Interior Backup cuts Too Long.

Resolution:

 Interior Backup Definition

The Interior Backup controls where the Blade Plunges into the Fallout (not the Matboard) on the Interior cuts.

Outside Interior Backup Too Short

Problem:

  • Interior Backup cuts Too Short.

Resolution:

 Interior Backup Definition

The Interior Backup controls where the Blade Plunges into the Fallout (not the Matboard) on the Interior cuts.

  • No labels