">
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this content. View the current version.

Compare with Current View Version History

« Previous Version 13 Next »

Cartridges Involved

This Configuration element involves the following Cartridges.

Note: Not all cartridges are available for all CMC models.

Rotation Definition on V-Grooves

The Rotation field controls how much the foot block will rotate before cutting. Because this is a V-Groove, you will be using either the Outside Rotation or the Inside Rotation, based on which V-Groove line you are editing.

  • The first cut is the interior V-Groove line.

  • The second cut is the exterior V-Groove line.

Adjust the Outside Rotation if you are getting Swoops or Flares in the outside corners on a non-oval opening.

Problem: V-Groove Outside has a Swoop

Problem:

The beginning of the outside cut of the V-Groove Swoops toward the non-oval V-Groove opening.

Resolution:

  • Decrease the Outside Rotation.

  • When making adjustments, click the minus button (-) at the end of the desired field about five or six times.

  • Click OK and do a test cut.

  • Check the results of the cut and continue making adjustments until the desired outcome is achieved.

  • The object will now cut correctly.

Problem: V-Groove Outside has a Flare

Problem:

  • The Outside V-Groove cuts with a Flare.

Resolution:

  • Increase the Outside Rotation value. 

  • When making adjustments, click the plus button (+) at the end of the desired field about five or six times.

  • Click OK and do a test cut.

  • Check the results of the cut and continue making adjustments until the desired outcome is achieved.

  • The object will now cut correctly.

See Also: V-Groove Inside Rotation

Problem:

  • The Inside Cut of the V-Groove cuts with a Swoop/Flare.

Resolution:

  • No labels