">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 18 Next »

Cartridges Involved

This Configuration element involves the following Cartridges.

Note: Not all cartridges are available for all CMC models.

Oval Rotation Definition

The Oval Rotation controls for Bumps or Feathers on the oval objects.

Current Bevel Type

Oval Opening has a Bump

Problem:

The opening is cut with a bump in the oval.

Resolution:

  • Increase the Oval Rotation. Adjust until the object cuts without a Bump.

  • When making adjustments, click the plus or minus button at the end of the desired field about four times.

  • In Rotation, eight points equals one degree of rotation. Users usually make adjustments four points at a time.

  • Click OK and do another test cut.

  • Check the results of the cut and continue making adjustments until the desired outcome is achieved.

Oval Opening has a Feather

Problem:

The opening is cut with a feather in the oval.

Resolution:

  • Decrease the Oval Rotation. Adjust until the object cuts without a Feather.

  • When making adjustments, click the plus or minus button at the end of the desired field about four times.

  • In Rotation, eight points equals one degree of rotation. Users usually make adjustments four points at a time.

  • Click OK and do another test cut.

  • Check the results of the cut and continue making adjustments until the desired outcome is achieved.

See Also: Troubleshooting Utility for Ovals

Problem:

  • The Circle/Oval V-Groove cuts with a Feather/Bump.

Resolution:

See Also: Circle/Oval Rotation Utility

Problem:

  • The Circle/Oval cuts with a Feather/Bump.

Resolution:

  • No labels