">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 53 Next »

Exterior Overcut on Creases

 How to Select the Bevel Type to Edit

Select desired Cartridge Tab. 

Select the desired Bevel Type from Current Bevel Type.

Edit the desired Configuration field.

 How to Adjust the Exterior Overcut

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

Crease Exterior Overcut Too Long

 Exterior Overcut of Creases Definition

The Overcut controls where the cartridge Retracts from the Matboard.

If the Overcut is Too Long, Decrease the Exterior Overcut.

The Overcut field is marked with a Red Arrow on the Configuration screen and the Map illustration.

 How to Adjust the Exterior Overcut

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

Crease Exterior Overcut Too Short

 Exterior Overcut of Creases Definition

The Overcut controls where the cartridge Retracts from the Matboard.

If the Overcut is Too Short, Increase the Exterior Overcut.

The Overcut field is marked with a Red Arrow on the Configuration screen and the Map illustration.

 How to Adjust the Exterior Overcut

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

  • No labels