Inset Rectangle (703/704) With Additional Openings

For Additional Information See:

Inset Opening Simple Design

Group Selection/Merge Openings

Click New Mat Design on the FrameShop Main Page.

Click Cancel on the New Openings Screen.

On the Openings Tab, bring the template #704: Inset Rect L onto the Editor.

Click on the Properties Tab to edit it.

Enter the desired size for the #704: Inset Rect L opening.

• Remember that we are going to merge the two halves together so keep that in mind when sizing the design.

Click on the Parameters Tab.

Adjust the Parameters as desired for the left side of this design.

On the Openings Tab, bring the template #703: Inset Rect R onto the Editor.

Click on the Properties Tab to edit it.

Enter the desired size for the #704: Inset Rect L opening.

• Remember that we are going to merge the two halves together so keep that in mind when sizing the design.

Click on the Parameters Tab.

Adjust the Parameters as desired for the left side of this design.

Position the openings as desired, overlapping the center edges.

Make sure that both layers of the designs overlap.

• If needed, go back and adjust the size of the openings and try overlapping again.

Select both openings and click the Group Selection button.

The two openings should merge where they overlapped.

If you need to make an adjustment to the design, click the Group Selection button to unmerge them, then click on the background to unselect them.

Re-edit as desired and then regroup them again.

The merged inset design is completed.

You can make a four corner Inset by copy/pasting the first two designs then Rotating them 180°.

Reposition them and edit the Parameters if desired and Merge them together