">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 11 Next »

  • The 45°+ Reverse Bevel Opening is created by cutting into the thicker matboard surface with the blade angled at 45°, thereby slanting the bevel under the matboard surface.

  • The matboard core is not visible from the front.

  • The Bevel Type refers to the angle at which the blade cuts the surface of the matboard when it deviates from the 90° right angle cut.

  • The Bevel Type determines the initial blade plunge position.

  • The Blade Depth must be above 16 in order for the CMC to prompt for the 45°+ Cartridge.

 45°+ Reverse Bevel Opening Full Definition

The 45°+ Reverse Bevel Opening is created by cutting into the thicker matboard surface with the blade angled at 45°, thereby slanting the bevel under the matboard surface.

The matboard core is not visible from the front.

The Bevel Type refers to the angle at which the blade cuts the surface of the matboard when it deviates from the 90° right angle cut.

The Bevel Type determines the initial blade plunge position.

Select Reverse Bevel or Reverse Bevel-Front of Mat from the Current Bevel Type dropdown control to edit this configuration.

See: 45 Degree Plus Reverse Bevel Opening Configurations

 How to Adjust the Configurations

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

  • No labels