">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 2 Next »

Drawing a Line

  • Click the Line button.

  • Click to place the two points of the Line:

    • Start Point

    • End Point

  • The drawn Line displays a Center Point which can be used to turn the Line into an Arc.

  • For Additional Information:

  • See Line Design Details for details displayed on the selected Line.

  • See Continuous Drawing to draw continuously without having to restart the current Drawing Tool command.

 How to Snap to Control Points When Drawing

Left-Click sets the Point under the Cursor.

Right-Click Snaps to the nearest Point.

Hold down the CTRL key to draw in Ortho Mode; i.e., Horizontally/Vertically only.

 Line Tool Definition

The Line/wiki/spaces/FrameShop8x/pages/1942694019tool in Trace will draw a Two-Point Line. 

The Line is defined by two points: Initial Position (called an Anchor) and the Terminating Position (called an Anchor).

After it is drawn, a third point in the Center will be displayed, which can be moved to alter the line into an /wiki/spaces/FrameShop8x/pages/1942509136.

See: Line Tool Function

  • No labels