Skip to end of metadata
Go to start of metadata
You are viewing an old version of this content. View the current version.
Compare with Current
View Version History
« Previous
Version 34
Next »
Cut the Outside as a Shared Edge: Cut Preview Outside Cut Options |
|---|
Select Shared Edge from the Outside Cut Options dropdown control to cut the shared edges of the outside cuts. The Shared Edge function will cut the Shared Edges of the Tiled Outside Cuts on the CMC Z1, Z(9000z), 9000 and 8000+ as one stroke between the designs, instead of cutting the outside of each mat individually.
|  |
When Tiling, make sure that the Spacing under the Setup Tab is set to Zero (0) so that each design shares the Outside lines with the next design, so it will only cut the single line between them. If you have Remnant Trimming on, it will also cut off the scrap edge.
|  |