">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 38 Next »

Cartridges Involved

This Configuration element involves the following Cartridges.

Note: Not all cartridges are available for all CMC models.

Rotation on Outsides Definition

 Rotation Definition

The Rotation controls for Swoops and Flares in non-oval objects.

If the Non-Oval Outside cuts with a Swoop, Increase the Rotation.

If the Non-Oval Outside cuts with a Flare, Decrease the Rotation.

 Swoop Definition

A Swoop in a Non-Oval Outside is where the corners curve inward toward the opening.

If the Non-Oval Outside cuts with a Swoop, Increase the Rotation.

 Flare Definition

A Flare in a Non-Oval Outside is where the corners curve away from the opening.

If the Non-Oval Outside cuts with a Flare, Decrease the Rotation.

Adjusting the Rotation

  • To adjust, click plus/minus on the desired field about five times.

  • Click OK and do another test cut.

  • Continue making adjustments until the desired outcome is achieved.

Current Bevel Type

Outside has a Swoop

Problem:

  • A Swoop in a Non-Oval Outside is where the corners curve inward toward the opening.

Resolution:

  • If the Non-Oval Outside cuts with a Swoop, Increase the Rotation.

Outside has a Flare

Problem:

  • A Flare in a Non-Oval Outside is where the corners curve away from the opening.

Resolution:

  • If the Non-Oval Outside cuts with a Flare, Decrease the Rotation.

Twisted Corner

Problem:

  • A Twisted Corner is when the blade turns before retracting from the matboard, which tears the matboard and twists the corner.

  • This is especially visible from the back of the mat.

Resolution:

  • Check to make sure the Rotation hasn't been set to a high number. 

  • Twisted corners can also be a symptom of oil/water in the Air Valve, or an issue with the Head.

  • Check the Air Regulator for excess water.

  • Use the Clean the Foot Block procedure for cleaning the foot block. 

  • No labels