Emergency Stop Button: CMC 8000 Series Containing an Emergency Stop Button
This page identifies and explains the operation of the Emergency Stop Button on the CMC 8000 Series that include this feature.
Aborting a Cut
The Emergency Stop Button on the CMC 8000 Series that contain this feature, allows you to immediately stop cutting and Release the Motors.
The Emergency Stop Button is located in one of two places:
On the lower left corner of the board
On the Control Panel on the side of the board
Hit the Emergency Stop Button to immediately abort the current cut and disengage the motors.
Push the Emergency Stop Button to Abort a Cut
Restart After Aborting a Cut
To restart cutting, pull out the Emergency Stop Button then close and reopen the FrameShop software.
You will be asked to Align the Head before cutting again.
See Align the Head for instructions on how to Align the Head.
Pull out the Emergency Contact Button and Realign the Head