Fixed Wall Mount Instructions: All Current CMC Models

Pick a spot on the wall that is at least 7 feet wide, or 9 feet if putting the computer on a stand alongside the Wizard.

Find two wall studs 48” apart towards the right side of the area.

The two shelf standards will mount on these studs.

The Wizard is 72” wide and it will rest on a shelf 48” wide.

If there is a choice, it is preferable to locate the left end of the machine closer to the support.

Measure up from the floor 68 inches at those two studs.

Use a level to make sure they are at the same level and not following a sloping floor.

Before mounting, make sure both Standards are facing the same direction (as the holes start off in a different position on each end).

Mount one of the shelf standards onto the wall using 2 ½” flat head screws, centering it over the 48” mark.

The top of the standard should be at the 68” mark.

Pre-drill into the studs, if you like, using a 7/64” drill.

Start at the top and use the level to make sure it is straight up and down.

Mount the second standard just the same, centering it over the other 48” mark.

Be careful to make sure that the two standards are 48” apart at the center point.

Measure 29” up both the shelf standards from the floor and install the 13” shelf support brackets.

Hook them in at the top first.

Then hook the angled supports into place at the bottom of the shelf standard.

Shelf support brackets are now in place.

Lay the shelf on the support brackets MAKING SURE THAT THE PILOT HOLES ARE ON THE TOP.

Make sure the shelf is pulled to the front edge of the shelf support bracket.

Install the shelf by starting with the pan head screws and affix the back first.

Find the two angled aluminum board stops.

Attach the shelf by placing the screws through the stops, then through shelf, then into the holes in the shelf support bracket to secure the front.

Install the other two screws (side away from edge) to finish the board stops.

NOTE: For the smaller Boards (43” wide) you have the option of installing either on one side or the other of the shelf or centered. Just make sure that the aluminum board stops are installed a minimum of 30” from each other and no more than 43” from each other measured from the outside.

Use the pan head screws and mount the aluminum board pads to the rounded end of the 5” standoff brackets.

The screw goes into the larger opening nearest the rounded end and through the standoff bracket...

...and into the board pad.

NOTE that this large hole may be on either side of the standoff bracket.

The board pad is installed on the same side on each bracket.

Measure up 36” from the shelf and install the standoff brackets onto the shelf standards in the same manner as you hooked in the shelf support brackets.

Rotate aluminum board stop slightly as the Wizard Board will lean against these.

The wall mount is complete.