Opening Cuts too Far Down Vertically (Not Cutting the Outside)

Opening Cuts too Far Down Vertically (Not Cutting the Outside)

If the Opening is cut Too Far Up Vertically, Decrease the Vertical Home.
If the Opening is cut Too Far Down Vertically, Increase the Vertical Home.

For Additional Information:
See Vertical Home which defines the global Vertical placement of objects cut with the Blade Cartridges.
See Vertical Home on the Troubleshooting Utility to adjust the bladed cartridges.
See Vertical Adjustment for placement adjustment of the non-blade Tools.

The Vertical Home defines the global Vertical placement of objects cut with the Blade Cartridges.

If the Opening is cut Too Far Up Vertically, Decrease the Vertical Home.

If the Opening is cut Too Far Down Vertically, Increase the Vertical Home.

Adjust the Vertical Home if the Opening cuts in the Wrong Place Vertically

Vertical Home Configurations

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

FrameShop 7x