Tape Measure Points: Properties Tab

• Point 1 and Point 2 are the two Yellow Control Points of the Tape Measure. 

• These points are referenced from the bottom-left of the design, which is 0,0.

Point 1 is the Lower Left point of the Tape Measure.

• X is the Horizontal position.

• Y is the Vertical position.

• Edit the fields to move the Tape Measure point.

Point 2 is the Upper Right point of the Tape Measure. 

• X is the Horizontal position.

• Y is the Vertical position.

• Edit the fields to move the Tape Measure point.