Select the Configurations Section to Edit

Calibration is the process of using the Configurations screen to make adjustments to the CMC to ensure that it is cutting the right size, in the correct position, the corners are precise, and there are no Swoops, Flares, Bumps or Feathers.

Open

Configurations Screen

Cutting from the Front will cut with the face of the mat toward the operator, and can be selected on the Cutting Preview.

• On the Configurations screen the Current Bevel Type dropdown control will display the bevel types in this manner:

  • Cut from the Back bevel type names will be displayed with no further label; i.e., Normal Bevel.

  • Cut from the Front bevel type names will be displayed with a Front label; i.e., Normal Bevel-Front of Mat.

  • V-Grooves have their own selection on the list.

If you are cutting an element that must be applied to the front of the mat, such as a V-Groove or Pen design, any openings on that layer will also cut from the front and use the Front of Mat configuration item; i.e., Normal Bevel-Front of Mat.

So if you are having problems with a Normal Bevel cut on the same layer as a V-Groove, make sure you select Normal Bevel-Front of Mat to edit the configurations for that opening.   

Open

A Cartridge is the physical component that holds the Blade, Deboss Stylus, Pen or other application tool.

A Cartridge is the physical component that holds the Blade, Deboss Stylus, Pen or other application tool.

A Bump in an Oval Opening is a Lump of material left behind where the cut started and ended.

If the Oval Opening has a Bump, Increase the Oval Rotation.

The Oval Rotation controls for Bumps or Feathers on an Oval Opening.

See: Oval Rotation Configurations

See: Oval Rotation for Openings Configurations

See: Oval Rotation for Drops Configurations

See: Oval Rotation for the Outside Configurations

See: Outside Oval Rotation for V-Grooves Configurations

See: Inside Oval Rotation for V-Grooves Configurations