This FrameShop Online Help System is for an older Version of FrameShop.
The updated 7.x FrameShop Online Help can be found here: https://wizardcutters.atlassian.net/wiki/x/hgApYw
If you are running FrameShop version FrameShop 4.1 or above you can update your software by clicking on Options then Check For Update.
What to Expect When Updating to FrameShop 7x from FrameShop 4x: https://wizardcutters.atlassian.net/wiki/x/AQDWaQ
FrameShop Installation Documents: https://wizardcutters.atlassian.net/wiki/x/_1snYw
Box 6: Snap Bottom Box: FrameShop Box Editor
Snap Bottom Box | |
---|---|
The sides fold over to create the box. For one end, the flaps tuck into each other to close. For the remaining end, a tab tucks into a flap to seal the box. This is cut from one piece of material. | |
Cut out the box at the desired dimension. | Remove the Cut Box from the CMC |
Fold the box sections along the creased edges. | Fold the Box Sections Along the Creased Edges |
Fold over the sides of the box and secure with hot glue. | |
Fold in the inner flaps of the box. | |
Fold over the tab into the tab opening created by the inner flaps of the box. | |
Fold over the flaps at the other end of the box. | |
Tuck the tab into the slot of the box to secure it shut. |