This FrameShop Online Help System is for an older Version of FrameShop.
The updated 7.x FrameShop Online Help can be found here: https://wizardcutters.atlassian.net/wiki/x/hgApYw
If you are running FrameShop version FrameShop 4.1 or above you can update your software by clicking on Options then Check For Update.
What to Expect When Updating to FrameShop 7x from FrameShop 4x: https://wizardcutters.atlassian.net/wiki/x/AQDWaQ
FrameShop Installation Documents: https://wizardcutters.atlassian.net/wiki/x/_1snYw
Box 7: Locking Tab Folding Box: FrameShop Box Editor
Locking Tab Folding Box | |
---|---|
The material folds over and tucks into tabs to form the sides. The lid folds over and tucks into the base then insert the tabs at the end into the base the secure the box. This is cut from one piece of material. | |
Cut out the box at the desired dimension. | Remove the Cut Box From the CMC |
Fold the box sections along the creased edges. | Fold the Box Sections Along the Creased Edges |
Fold in the inner flaps of the box. | |
Fold over the side over the inner flaps of the box. | |
Tuck the tab of the side of the box into the bottom of the box, securing it in place. | |
Fold in the inner flaps on the other side of the box. | |
Fold over the other side over the inner flaps of the box. | |
The two sides are secured in place. | |
Insert the top part of the box into the base. | |
Insert the tabs from the top part of the box into the base to secure the box. | |
The box is completed. |