This FrameShop Online Help System is for an older Version of FrameShop.
The updated 7.x FrameShop Online Help can be found here: https://wizardcutters.atlassian.net/wiki/x/hgApYw
If you are running FrameShop version FrameShop 4.1 or above you can update your software by clicking on Options then Check For Update.
What to Expect When Updating to FrameShop 7x from FrameShop 4x: https://wizardcutters.atlassian.net/wiki/x/AQDWaQ
FrameShop Installation Documents: https://wizardcutters.atlassian.net/wiki/x/_1snYw
Rotation on Outside: FrameShop Configurations Screen
- dani.simmonds
Outside Rotation | |
|---|---|
The Rotation field controls how much the Footblock will rotate before cutting. Adjust the Rotation if you are getting Swoops or Flares in the corners on a non-oval outside. If you have too much Rotation on a non-oval outside you will get a Flare, too little rotation and you will get a Swoop. |  Rotation Adjusts for Swoops or Flares in the Corners on a Non-Oval Opening |
Current Bevel Type | |
|---|---|
Select the desired Cartridge Type Tab and then the bevel type you want to edit from the Current Bevel Type dropdown control before making adjustments. Select Current Bevel Type-Front of Mat if it is being cut from the front of the mat. |  Select the Desired Bevel Type From the Bevel Type Dropdown Control |
Degrees of Rotation for Non-Oval Openings | |
|---|---|
In Rotation, eight points equals one degree of rotation. Users usually make adjustments 4 points at a time. Increase the Rotation to turn the Footblock clockwise to correct for a Swoop. Decrease the Rotation to turn the Footblock counterclockwise to correct for a Flare. | |
Outside has a Swoop | |
|---|---|
The beginning of the cut swoops toward the non-oval outside. | |
Increase the Rotation. | |
The object will now cut correctly. | |
When making adjustments, click either the minus or plus button (-/+) at the end of the desired field about five or six times in the direction indicated. Click OK and do a test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved. | |
Outside has a Flare | |
|---|---|
The beginning of the cut flares away from the non-oval outside. | |
Decrease the Rotation. | |
The object will now cut correctly. | |
When making adjustments, click either the minus or plus button (-/+) at the end of the desired field about five or six times in the direction indicated. Click OK and do a test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved. | |
Twisted Corner | |
|---|---|
A Twisted Corner is when the blade turns before retracting from the matboard, which tears the matboard and twists the corner which is especially visible on the back of the mat. Check to make sure the Rotation hasn't been set to a high number. Optionally, see the Clean the Footblock procedure for information on cleaning the Footblock. Twisted corners can also be a symptom of oil/water in the Air Valve, or an issue with the Head. Check the Air Regulator for excess water. | |