This FrameShop Online Help System is for an older Version of FrameShop.
The updated 7.x FrameShop Online Help can be found here: https://wizardcutters.atlassian.net/wiki/x/hgApYw
If you are running FrameShop version FrameShop 4.1 or above you can update your software by clicking on Options then Check For Update.
What to Expect When Updating to FrameShop 7x from FrameShop 4x: https://wizardcutters.atlassian.net/wiki/x/AQDWaQ
FrameShop Installation Documents: https://wizardcutters.atlassian.net/wiki/x/_1snYw
Width Adjustment (V-Groove): FrameShop Configurations Screen
- dani.simmonds
V-Groove Width Adjustment | |
|---|---|
Adjust the Width Adjustment if the V-Groove is cutting too thin or too wide. |  The Width Adjustment Field Controls the Width of the V-Groove Line |
Current Bevel Type | |
|---|---|
Make sure to select the desired Cartridge Tab and then select V-Groove from the Current Bevel Type dropdown control before making adjustments. |  Select the V-Groove Bevel Type From the Bevel Type Dropdown Control |
V-Groove Width is too Thin | |
|---|---|
The V-Groove is cutting too thin. |  V-Groove is Cut too Thin |
Increase the Width Adjustment. |  Increase the Width Adjustment |
The object will now cut correctly. |  Test Cut and Adjust Until the V-Groove is the Correct Size |
When making adjustments, click either the minus or plus button (-/+) at the end of the desired field about five or six times in the direction indicated. Click OK and do a test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved. |  Test Cut and Adjust Until the V-Groove is the Correct Size |
V-Groove Width is too Wide | |
|---|---|
The V-Groove is cutting too wide. |  V-Groove is Cut too Wide |
Decrease the Width Adjustment. |  Decrease the Width Adjustment |
The object will now cut correctly. | Test Cut and Adjust Until the V-Groove is the Correct Size |
When making adjustments, click either the minus or plus button (-/+) at the end of the desired field about five or six times in the direction indicated. Click OK and do a test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved. | Test Cut and Adjust Until the V-Groove is the Correct Size |
Opening Adjustment: V-Groove | |
|---|---|
To adjust the opening size of the V-Groove, see Opening Adjustment: V-Groove. |  Opening Adjustment Controls the Width of the V-Groove Opening |
Width of an Open V-Groove | |
|---|---|
To adjust the width of an Open V-Groove, see VG-Width in the V-Groove Properties. |  Use VG-Width to Adjust the Width of an Open V-Groove |
A VG-Width value larger than zero is an Open V-Groove. |  A VG-Width Larger Than Zero is an Open V-Groove |