This FrameShop Online Help System is for an older Version of FrameShop.
The updated 7.x FrameShop Online Help can be found here: https://wizardcutters.atlassian.net/wiki/x/hgApYw
If you are running FrameShop version FrameShop 4.1 or above you can update your software by clicking on Options then Check For Update.
What to Expect When Updating to FrameShop 7x from FrameShop 4x: https://wizardcutters.atlassian.net/wiki/x/AQDWaQ
FrameShop Installation Documents: https://wizardcutters.atlassian.net/wiki/x/_1snYw
Horizontal Home for Openings: FrameShop Configurations Screen
- dani.simmonds
Horizontal Home for Openings | |
|---|---|
The Horizontal home defines the global horizontal placement of objects cut with the blade cartridges.  |  Adjust the Horizontal Home if the Opening is Cut in the Wrong Place Horizontally |
Opening Cuts too Far to the Right when Not Cutting the Outside: Horizontal Border too Big | |
|---|---|
Adjust the Horizontal home if the opening is cutting too far to the right (as it sat on the board) when you are not cutting the outside of the mat. This is measured from the inside of the bevel to the edge of the mat. | |
This is viewed as it cut on the machine, i.e., from the back if cutting from the back, or from the front if cutting from the front. The opening is cutting too far to the right. |  The Opening is Cut too Far to the Right |
Decrease the Horizontal home. When making adjustments, click the plus or minus button at the end of the desired field about five times. Click OK and do another test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved. | |
The opening will move to the left. | |
Opening Cuts too Far to the Left when Not Cutting the Outside: Horizontal Border too Small | |
|---|---|
Adjust the Horizontal home if the opening is cutting too far to the left (as it sat on the board) when you are not cutting the outside of the mat. This is measured from the inside of the bevel to the edge of the mat. | |
This is viewed as it cut on the machine, i.e., from the back if cutting from the back, or from the front if cutting from the front. The opening is cutting too far to the left. | |
Increase the Horizontal home. When making adjustments, click the plus or minus button at the end of the desired field about five times. Click OK and do another test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved. | |
The opening will move to the right. | |
Horizontal Home Troubleshooting | |
|---|---|
Alternatively, adjust the Horizontal home on the Troubleshooting Screen. | |
Adjusting the Horizontal Position for Non-Blade Cartridges | |
|---|---|
To adjust the Horizontal placement of the non-blade cartridges, (i.e., Deboss, Pen or Vinyl tools), see Horizontal Adjustment. | |