This FrameShop Online Help System is for an older Version of FrameShop.

The updated 7.x FrameShop Online Help can be found here: https://wizardcutters.atlassian.net/wiki/x/hgApYw

If you are running FrameShop version FrameShop 4.1 or above you can update your software by clicking on Options then Check For Update.

What to Expect When Updating to FrameShop 7x from FrameShop 4x: https://wizardcutters.atlassian.net/wiki/x/AQDWaQ

FrameShop Installation Documents: https://wizardcutters.atlassian.net/wiki/x/_1snYw


90 Degree Outside Toggle: FrameShop Cut Preview Screen

Cut Outside Using 90 Degree Tool

Cut Outside Using 90 Degree Tool

Use the Cut Outside using 90 Degree Tool toggle whether to cut the outside of the mat with the 90 Degree cartridge on the CMC Z1 and Z (9000z).

To select the 90 Degree Outside Cut for the CMC 9000, see 90 Degree Outside Cut.

The CMC 8000 does not have the capability to cut the outside with the 90 degree cartridge.

Set Advanced Options: Cut Outside using 90 Degree Tool

Set Advanced Options: Cut Outside using 90 Degree Tool

Click the Set Advanced Options button on the Cut Preview to access the Advanced Outside Options. 

Select the desired outside 90 Degree setting from the Cut Outside Using 90 Degree Tool toggle.  

Click OK.

The CMC will cut the outside of the mat with the selected setting.

90 Degree Cartridge Toggle On

90 Degree Cartridge Toggle On

Click the Cut Outside Using 90 Degree Tool toggle to On to use the 90 Degree Cartridge when cutting the outside.

Click the Set Advanced Options button on the Cut Preview to access the Advanced Outside Options. 

Click the Cut Outside Using 90 Degree Tool toggle to On. 

Click OK.

It will cut the outside of the mat with the 90 Degree Cartridge when the Cut the Outside toggle is On. 

90 Degree Cartridge Toggle Off

90 Degree Cartridge Toggle Off

Click the Cut Outside Using 90 Degree Tool toggle to Off to use the 45 Degree Cartridge when cutting the outside.

Click the Set Advanced Options button on the Cut Preview to access the Advanced Outside Options.  

Click the Cut Outside Using 90 Degree Tool toggle to Off. 

Click OK.

It will cut the outside with the 45 Degree Cartridge when the Cut the Outside toggle is On.

In this mode, the other settings on the Advanced Outside Options screen are grayed out.

Set the Default for Cutting the Outside 

Set the Default for Cutting the Outside 

The default setting for Cutting the Outside can be set in the Admin > Editor section.

Set the Default for 90 Degree Outside Cut

Set the Default for 90 Degree Outside Cut

The default setting for 90 Degree Outside can be set in the Admin > Cutting section.