WARNING: To avoid damage to the Head, do not loosen the Head Wheel Adjustment Screws without first Aligning the Head to the middle of the Board.
Adjust the Head Wheel Adjustment Screws if the Head Wheels are loose, which may cause swooping, notches, not cutting through on one side of the mat and other similar problems.
note
Go to the Cut Preview screen.
Click the Power Button to Align the Head.
Go to the Cut Preview screen.
Click the Power Button to Align the Head.
note
Locate the Allen Head Wheel Adjustment Screws on the left side of the Head under the Head Faceplate.
They are next to the Head Wheels and are marked with red dots.
Do not touch the Allen screws on the Head Wheels themselves.
Loosen each Allen Head Wheel Adjustment Screw only until the Head Wheels are loose; about two full turns.
The Head Wheels are spring-loaded and will pop into place.
Locate the Allen Head Wheel Adjustment Screws on the left side of the Head under the Head Faceplate.
They are next to the Head Wheels and are marked with red dots.
Do not touch the Allen screws on the Head Wheels themselves.
Loosen each Allen Head Wheel Adjustment Screw only until the Head Wheels are loose; about two full turns.
The Head Wheels are spring-loaded and will pop into place.
note
Grasp the Head with both hands and gently rock it back and forth to ensure that the Head Wheels are lined up to the Gantry Grooves.
Grasp the Head with both hands and gently rock it back and forth to ensure that the Head Wheels are lined up to the Gantry Grooves.
note
Holding the Head up so that it is level with the Board, retighten the Allen Head Wheel Adjustment Screws consecutively; tighten the top screw half a turn, then the bottom screw half a turn, back to the top and continue until they are both tight.
Holding the Head up so that it is level with the Board, retighten the Allen Head Wheel Adjustment Screws consecutively; tighten the top screw half a turn, then the bottom screw half a turn, back to the top and continue until they are both tight.
note
Check each of the Head Wheels to make sure there is no movement.
There are the two visible wheels on the left side of the Head behind the Head Faceplate, and two wheels on the backside of the Gantry, which can be felt by hand.
They should sit firmly into the Gantry Groove and be difficult to turn.
Check each of the Head Wheels to make sure there is no movement.
There are the two visible wheels on the left side of the Head behind the Head Faceplate, and two wheels on the backside of the Gantry, which can be felt by hand.
They should sit firmly into the Gantry Groove and be difficult to turn.
note
If not, repeat the steps above for Head Wheel Adjustment.
If not, repeat the steps above for Head Wheel Adjustment.
note
Click the Reset Motors button on the Cut Preview Screen.
Align the Head and install the Blade Cartridge.
Click the Reset Motors button on the Cut Preview Screen.
Align the Head and install the Blade Cartridge.
Call Technical Support if you have any questions at 425/551-4300 or 888/855-3335.
