You are viewing an old version of this page. View the current version.
Compare with Current View Page History
« Previous Version 3 Next »
Select As Designed for the Cut Mode to default to cutting the outside as originally designed.
This can be helpful when coming from Trace or Nesting where the outside cut had been pre-determined.
Select As Designed for the Cut Mode to default to cutting the outside as it was originally designed.
For Additional Information:
See Cut Mode in the Set Advanced Options section on the Cut Preview.
See As Designed for the Cut Mode in the Set Advanced Options section on the Cut Preview.
As Designed: Cut Mode Advanced Options
Cut Mode Set Advanced
Full Cut: Cut Mode Advanced Options
Outside Cut Off: Cut Mode Advanced Options
Shared Edge: Cut Mode Advanced Options
Cut Mode: Cutting Default Setting
Shared Edge Cut Mode: Cutting Default Setting
Full Cut Mode: Cutting Default Setting
As Designed Cut Mode: Cutting Default Setting
