You are viewing an old version of this content. View the current version.
Compare with Current View Version History
« Previous Version 30 Next »
The Exterior Overcut controls where the Blade Retracts from the Matboard (not the Fallout) on the Exterior Cuts of Openings.
The Exterior Cuts is where the Blade Plunges/Retracts from the Matboard (not the Fallout).
If the Exterior Overcut is cut Too Long, Decrease the Exterior Overcut.
If the Exterior Overcut is cut Too Short, Increase the Exterior Overcut.
When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.
Click OK and do another test cut.
Continue making adjustments until the desired outcome is achieved.
