">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 50 Next »

Contents:

  • The Exterior Overcut controls where the Blade Retracts from the Matboard (not the Fallout) on the Exterior Cuts of Openings.

  • The Exterior Cuts is where the Blade Plunges/Retracts from the Matboard (not the Fallout).

    • If the Exterior Overcut is cut Too Long, Decrease the Exterior Overcut.

    • If the Exterior Overcut is cut Too Short, Increase the Exterior Overcut.

BackupOvercutEOArrows70800.png

 How to Adjust the Exterior Overcut

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

  • No labels