">

Click here to check out our new How To section">Click here to check out our new How To section

Skip to end of banner Go to start of banner

Dense Material Cut Speeds

Skip to end of metadata

Created by dani.simmonds on Aug 15, 2024

Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Dense Material Cut Speeds

This is a feature of the VPO Head; not all CMC models have this feature.

Click Dense Material if this is dense material and Click OK.
When you click Cut, the Head plunges at the Home position and applies the current Air Pressure.
The user is prompted to adjust the Head Pressure to the High Setting.

For Additional Information:
See Variable Pressure Optimization (VPO) for more information.
See Adjusting the Air Pressure for Typical Matboard for more information.
See Adjusting the Air Pressure for Dense Matboard for more information.
See Adjusting the Air Pressure for Extra Dense Matboard with the 90° Cartridge for more information.

Default Settings: See Admin > Cutting for the default settings for the Default Speed Percentage for Dense Material.

No labels