">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 12 Current »

How to Mirror the #503: Leaf in Trace

  • These instructions will show you how to Mirror the #503: Leaf by turning it into a CutArt in Trace.

504LeafQuadDone800.png

  • Create your design using the current #503: Leaf.

  • Right-Click on the #503: Leaf and select Convert to CutArt

503MirrorConvertToCutArt800.png

  • The design will open up in Trace.

  • We are not making any edits to the design; just saving it under a different file format.

  • Click File > Save As.

503MirrorTraceSaveAs800.png

  • Make sure that the CutArt directory is selected.

  • Make sure that the CutArt filetype is selected.

  • Give it a filename and click Save.

503MirrorSaveCutArt800.png

  • Close Trace.

  • Start a new Designer design.

  • On the Openings Tab click Add CutArt.

  • In the Wizard/CutArt directory, locate your CutArt and click Design.

503MirrorAddCutArt800.png

  • With the CutArt selected, click on the Properties Tab.

  • Click Mirror the CutArt.

  • The CutArt is now mirrored.

503MirrorMirrored800.png

  • The mirrored #503: Leaf is now complete.

  • With the same CutArt opening, you could cut it mirrored or unmirrored.

504LeafQuadDoneFinished800.png
  • No labels