How Tosectionat:[HowTo...]">Check out our new How To section at: How To...

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 3 Current »

Single Tab: Reverse Bevel

  • Select the Reverse Bevel checkbox to make the selected layer a Reverse Bevel.

  • Select the RB button to make all of the layers Reverse Bevel.

  • Default Settings:

  • See Admin > Editor for the default settings for the Number of Layers for templates placed on the Design Editor.

  • See Admin > Defaults for setting the default layer Reveal values for templates placed on the Design Editor.

 Reverse Bevel Definition

The Reverse Bevel Opening is created by cutting into the matboard surface with the blade angled at 45°/52°, thereby slanting the bevel under the matboard surface. The matboard core is not visible from the front.

The Bevel Type refers to the angle at which the blade cuts the surface of the matboard when it deviates from the 90° right angle cut.

Select Reverse Bevel or Reverse Bevel-Front of Mat from the Current Bevel Type dropdown control to edit this configuration.

BevelType45RBSelect70800.jpg

See: 45 Degree Reverse Bevel Opening Configurations

See: 45 Degree Plus Reverse Bevel Opening Configurations

See: 45 Degree Front Reverse Bevel Opening Configurations

See: 52 Degree Reverse Bevel Opening Configurations

NOSSingleRB70800.png

  • No labels