">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 3 Next »

How to Make the Star of David Using #506: Star

  • These instructions will show you how to get the Star of David shape with the #506: Star template.

StarDavidDone800.png

  • Click New Mat Design on the FrameShop Main Page.

  • Click Cancel on the New Openings Screen.

  • On the Openings Tab, bring the template #506: Star template onto the Editor.

  • Click on the Properties Tab to edit it.

  • Enter the desired size for the #506: Star opening.

StarDavidStart800.png

  • If you click on the Template Parameter Map button, you will see that there are Three Modes to this particular template.

  • Mode 0 - Size scaled to fit Opening size.

  • Mode 1 - Width and Height the same, using Opening Width.

  • Mode 2 - Width and Height the same, using Line Length parameter.

  • Line Length - Side length of each star point, only used for Mode 2.

StarDavidParamMap800.png

  • Click on the Parameters tab.

  • Change the No. of Points to 6.

  • Change the Spikiness to 36.

  • Change the Mode to 1.

StarDavidParameters800.png

  • Our Star of David shape is now complete.

StarDavidDone800.png
  • No labels