How Tosectionat:[HowTo...]">Check out our new How To section at: How To...

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 13 Next »

90° Cartridge Definition

  • The 90° Cartridge cuts a 90° Right Angle into the matboard.

  • The matboard core is not visible from the front as there is no Bevel Type cut at 90° Right Angle.

  • The Bevel Type refers to the angle at which the blade cuts the surface of the matboard when it deviates from the 90° right angle cut.

  • The Bevel Type determines the initial blade plunge position.

 90 Degree Cartridge Full Definition

The 90° Cartridge cuts a 90° Right Angle into the matboard. The matboard core is not visible from the front. The initial plunge position is determined by the bevel type.

The Bevel Type refers to the angle at which the blade cuts the surface of the matboard when it deviates from the 90° right angle cut.

Select [Bevel Type] or [Bevel Type]-Front of Mat from the Current Bevel Type dropdown control to edit this configuration.

See: 90 Degree Bevel Opening Definition

See: 90 Degree Bevel Drop Definition

See: 90 Degree Outside Definition

See: 90 Degree Bevel Open V-Groove Definition

 How to Adjust the Configurations

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

  • No labels