Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 5 Current »

Straight Line Trimmer Installation: Slide on the Straight Line Trimmer

  • NOTE: A Blade has been installed, so take care when handling the Straight Line Trimmer.

  • Look at the backside of the Trimmer and locate the T-Nut on the glides. Make sure that the T-Nut lines up with the glide on both the upper and lower sections of the Trimmer.

  • Holding the Straight Line Trimmer steady (a second person helps here), carefully slide the Trimmer onto the channels on the right side of the Board, making sure that the T-Nuts slide into the channel of both the upper and lower rails.

Lock the Straight Line Trimmer in Place

  • Move the Straight Line Trimmer to the right until it stops.

  • Slowly tighten the bottom locking knob COUNTER-CLOCKWISE until it is snug.

  • Slowly tighten the top locking knob CLOCKWISE until it is snug. You will calibrate it after the air lines are hooked up.

  • No labels