Skip to end of metadata
Go to start of metadata
You are viewing an old version of this page. View the current version.
Compare with Current
View Page History
« Previous
Version 50
Next »
|
---|
| |
| |
Fold the ends of the packing inserts down again, covering the ends of the trimmer. Secure the box with tape.
| |
|
---|
| |
| |
Locate the 3/16” Allen belt tensioner screw that’s located on the right bottom side of the lower rail and marked with a red dot. Loosen this screw one turn only so that there is some movement in the belt tensioner. The tensioner springs should be visible.
| |
| |
Locate the belt tensioner hole on the end of the belt tensioner. Place the 5/32” Allen screw and washer we removed from the lower gantry plate into the belt tensioner hole. Tighten the Allen screw until belt tensioner is flush with the rail and the springs are not visible.
| |
| |
| |
| |
|
---|
Move the gantry far enough to the left to dislodge the belt anchors. The belt anchors are sunk into the left ends of the rails and are attached to the drive belts. See the instructions following for the type of Gantry Stop your machine has.
| |
|
---|
If the shipping blocks have been misplaced, please find a way to secure the gantry so that it does not move during shipment. Loosely place the T-Nut onto the shipping blocks and slide onto the rail on each side of the gantry as described next.
| |
| |
Place the other two shipping blocks on the lower rail. One should be to the left side of the gantry on the underside of the bottom rail and one on the top of the bottom rail. Tighten into place. Place the other shipping block to the right of the gantry on the top of the bottom rail.
| |
|
---|
| |
| |
Place the head box and the ECU box between the gantry and the side of the box between the foam corners. Secure the board in place with additional packing material if needed. Secure the box closed with banding or packing tape. The system is now ready to be moved.
| |