Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 26 Next »

Vertical Belt Tension: CMC 8500eSBT, 8500e, 8500, 8000 and 8000RC

  • Reset the vertical tension if the vertical belt feels loose.

  • Click Reset Motors to turn off power to the motors.

  • Manually move the Head to the top of the Gantry and down again.

  • Remove the lower gantry cover by removing the screw holding it in place.

  • Manually move the head up on the gantry.

  • With an 1/8” Allen wrench, loosen the Vertical Tension Screw on the bottom of the Gantry rail NEAR the screw that holds the Toothed Pulley.

  • You may see the Toothed Pulley spring out downward.

  • Snugly retighten the screw.

  • Reinstall the gantry cover, replacing the screw you removed earlier.

  • No labels