Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 47 Next »

  • The drivers for the ECU must be installed on the Computerized Mat Cutter (CMC) computer. 

  • The drivers will install two parts.

  • The first part installs the drivers for the ECU, and the second part installs the firmware for the ECU. 

  • If both parts are not installed, the ECU may not function properly.

  • Turn off the ECU.

  • Unplug the USB Cable from the ECU. 

  • It is necessary to turn off and unplug the ECU, otherwise the ECU memory will not clear and the drivers installation will NOT take full effect.

  • Start up the FrameShop installation to go to the Installation Main Screen.

  • Click on the Advanced button.

AdvancedInstall70800.png

  • Click on the Install CMC Drivers button.

  • If you get a security warning, click Run Anyway.

InstallCMCDriverStartedLater70800.png

  • Select Install ECU.

  • If you get a security warning, click Run Anyway.

InstallInstallECU70800.png

  • Click Next on the Drivers Welcome Screen.

18DriversWelcome70800.png

  • On the Congratulations Screen, click Finish.  It displays the first part of the driver is installed.

19Congratulations70800.png

  • It will then start the second installation. On the Drivers Welcome Screen, click Next.

On the Congratulations Screen, click Finish.  It displays that the second part of the driver is installed.

  • Plug in the USB Cable to the ECU.

  • Turn on the ECU.

  • On the completion screen, click the Release button to read the Release Notes if desired.

  • Click Quit to close the installation screen. 

  • The drivers are now installed.

InstallDriversBack70800.png

  • Start up the FrameShop software by double-clicking on the icon on the desktop.

  • No labels