Skip to end of metadata
Go to start of metadata
You are viewing an old version of this page. View the current version.
Compare with Current
View Page History
« Previous
Version 29
Next »
Cut the Outside On |
|---|
Click the Cut Outside toggle On to cut the outside of the mat. The outside of the mat will now cut. Optionally, select Options > Cut Outside.
|  |
Cut the Outside Off |
|---|
|  |
|
|---|
Click on the design to select it. Check the Auto Offset checkbox. Enter the distance to move the design in the X Origin field; the Y Origin field uses the same numerical value. It will move the lower left corner of the design to the new X/Y Position and it will display Dodge on the bottom of the screen. This feature is also turned on by selecting Full from the Outside Cut Options dropdown control.
|  |
|
|---|
Click on the design to select it. Uncheck the Auto Offset checkbox. The design will no longer be offset and will cut the design normally unless values have been entered in the X Origin and Y Origin fields as described above. This is useful when cutting the opening from a pre-cut sheet matboard and not cutting the outside.
| |